P0500codes can be caused by: Failed vehicle speed sensor (the sensor itself has died/stopped working) Open or short in the wiring harness (can happen over time due to normal wear and tear) Damaged vehicle speed sensor drive gear (another wear and tear issue) Poor electrical connection (may take a little time to figure out where the connection HowABS Works. Common Bad ABS Control Module Symptoms. 1) Brakes Locking. 2) ABS Light On. 3) Brake Pedal is Unresponsive. 4) Increased Brake Pedal Effort. 5) Speedometer Fails. ABS Control Module Replacement Cost. Thelocation of the automatic transmission speed sensor is on the long- side of your output shaft just close the longitudinal transmission mount of your car. To find the Speed Sensor, simply look inside the gearbox case. It is on the passenger side of the output flange. Transmission: automatic On the right side of the transmission, near the Whenan ignition coil goes bad, the Check Engine Light comes on, either solid or flashing. It can also cause a misfiring or stalling engine, along with a rough idle. You may also notice rough acceleration, poor fuel economy, a hard-starting engine or exhaust gases that smell like fuel. Here are the symptoms to watch for. Theonly major symptom of bad wheel speed sensor in Jeep Cherokee is the ABS warning light comes on in the instrument cluster, and the anti-lock braking system is disabled. When the ABS light / comes on in your Cherokee, the anti-lock braking system is disabled. The vehicle can still be braked without ABS. BadWheel Speed Sensor Symptoms. Bad wheel sensors' most common symptoms include active traction light, ABS warning light being on, braking problems, pulsating brake pedal, and loss of stability control. When the speed sensor fails, these symptoms will be noticeable because the vehicle displays different warning signs when the car isn't 0i5wD9m.

symptoms of a bad vehicle speed sensor